Swadesh Products
Sonnet Products
As Per Is : 2202 (Part -1):1999
Flush Doors
Swadesh flush Doors are a wide range of elegant doors made by a mechanized manufacturing process which offers uniform thickness without any undulation. They provide all the key functions of a top quality door including security, protection from weather, privacy and status value which comes with their good look. Flush Doors are manufactured from specially selected & well seasoned pine/hardwood timber. Solid block beard core is framed with seasoned pine/hard wood battens in kiln seasoned stiles & rails and strengthened by a layer of Cross-brands. Gurjan face veneers encompass both sides of the core. All these are bonded high pressure and temperature, with phenol formaldehyde synthetic resin as per IS:848 and permanent type preservatives, under the cross-bonding process.
Features:
-
Uniform thickness and smooth for lamination.
-
No warping, bending, bulging, shrinkage, brittleness and cracks.
-
Sufficient strength in both horizontally and vertically to prevent sagging and deformation under load or impact on slamming as well as resistance to normal knocks and blows.
-
Dimensional accuracy and stability in varying humidity.
-
Adequate provision for fixing the lock and screwing the hinges.
-
High screw holding capacity.
-
Totally resistant to termite and borers.
-
Available in BWP & MR grades both Decorative & Nondecorative type.
-
Thickness : 25mm, 30mm, 32mm, 35mm
-
Standard sizes (ft) : Normally the size in made as per the order which varies.
SWADESH GOLD FLUSH DOOR
TECHNICAL SPECIFICATIONS (IS:2202)
| SI NO. | TEST | ISI REQUIREMENT | OBSERVED VALUE |
|---|---|---|---|
| 1 | Dimension | Length, width - + 5mm Thickness - + 1 mm | Within limits |
| 2 | Squareness | Deviation not more than 1 mm on a length of 500mm | Deviation below 1 mm |
| 3 | General Flatness | Twist, cupping, wrapping not to exceed 6 mm | |
| 4 | Local Planeness | Depth of deviation at any point to be less than 0.5 mm | Within limits |
| 5 | Impact Indentation Test | Depth of Indentation not to exceed 0.2 mm | Within Limits |
| 6 | Edge loading Test | Deflection of edge with max, To be less than 5 mm | Within Limits |
| 7 | Shock Resistance Test | No visible defect after test | No visible defects |
| 8 | Buckling Test | Initial Deflection - <50 mm, Residual deflection - <5 mm | Within limits |
| 9 | Slamming Test | No Visible damage after Test | No Visible Damage |
| 10 | Misuse Test | No deformation after Test | No Deformation |
| 11 | Varying Humidity Test | No visible warping, twisting or de-lamination | No such defects observed |
| 12 | End Immersion Test | No de-lamination at the end | No de-lamination |
| 13 | Knife Test | Minimum Pass Standard | Excellent |
| 14 | Glue Adhesion Test | No de-lamination | No de-lamination |
| 15 | Screw Withdraw Test | Load to withdraw screw, To be more than 1000N | Load - > 1000 N |
Get In Touch
Ready to Start Your Project?
Get in touch with our team for expert advice and premium quality products for your next project.